Only logged in customers who have purchased this product may leave a review.
DC Buzzer -3-24V
₦ 1,000
These 3-24V buzzers allow you to give audible notification from your using any microcontroller or Arduino with or without a transistor.
- 3-24V Operating Voltage
- 90dB Sound Intensity
- Easy to connect cables
20 in stock
Related Products
-
12V Relay – 10A – 1 Pair
₦ 850The JCQ-3FF 12V Relay allows your to control loads with up to 10A consumption
Features:
-
- 12V Coil
- Maximum Load DC: 24V (DC) @ 10A
- Maximum Load AC: 240V (AC) @ 10A
- Maximum turn-on time: 10ms
- Maximum turn-off time: 5ms
- Easy through hole mounting arrangement
Qucik View -
-
Dupont Cable
₦ 1,000These cables are excellent for all your prototyping needs. Easily connect Raspberry Pi, Arduino boards, ARM based boards and start hacking away.
30 cables in total
- 10 Male-to-Male
- 10 Male-to-Female
- 10 Female-to-Female
Qucik View -
5 Red LEDs + 5 Resistors
₦ 6005 Red LED with 5 330 Ohm resistors. With these, all that needs to be done is connect to Microcontroller or Arduino GPIO pins. Works fine for 5V or 3V circuits
Qucik View -
Stepper Motor – Nema 17 + A4988 Driver
₦ 9,000This stepper motor is perfect for robotics, 3D printer and other kinds of high precision projects. 1.8° per step smooth motion. The included A4988 motor driver allows you to safely, quickly and accurately working with the motor.
- 200 steps/rev
- 12V Operating Voltage
- 350mA (Max Current)
- 1.8 degrees per step
- Bipolar stepper motor
- 20 N*cm, 2 Kg*cm holding torque per phase
- 35 ohms per winding
- 42mm X 42mm square body -M3 Mounting Screws
Qucik View -
R2323 to TTL Converter with Dupont Cable
₦ 1,600This module suitable for any 3.3v or 5v microcontroller and Arduino
• Fully compatible with existing legacy COM port software
• Output signals: VDD, TXD, RXD, CTS, RTS, GND
• Power, TX, RX LED
• Power input: 3.3V or 5VPackage List:
1 * RS232 Serial To TTL Converter Module
4 * Dupont Jumping CableQucik View -
Arduino Buzzer Module
₦ 800This module allows you to produce a rich and loud sound from your microcontroller.
- 3.3 V to 5 V Operating Voltage
- 3V to 5V Control
- Works without the need of a separate transistor
- Mounting Hole
Pin Out
-
- VCC (3.3 V to 5 V)
- GND
- I/O Control
Qucik View
Reviews
There are no reviews yet.