This is DC 3-5V X9C103S Digital Potentiometer Board Module. The X9C103 are digitally controlled (XDCP) potentiometers. The device consists of a resistor array, wiper switches, a control section, and non-volatile memory. The wiper position is controlled by a three-wire interface.
This is DC 3-5V X9C103S Digital Potentiometer Board Module. The X9C103 are digitally controlled (XDCP) potentiometers. The device consists of a resistor array, wiper switches, a control section, and non-volatile memory. The wiper position is controlled by a three-wire interface.
Supply voltage: 3V-5V Operating Range
10k Span Potentiometer.
Three-Wire Serial Interface
Dimensions : 28 x 14 x 4 (LxWxH) mm.
Potentiometer center tap between 0-10k slide in total 100 (potentiometer wiper typical impedance 40 ohms)
VL and VH digital potentiometer sliding rheostat port corresponding to the low-end and high-end, allowing the input voltage range -5V to + 5V.
Reviews
There are no reviews yet.
Only logged in customers who have purchased this product may leave a review.
Related Products
0 out of 5
AT24C256 256Kb EEPROM Memory Module (I2C Bus)
₦ 2,000
The 256Kb EEPROM on this chip allows settings and user data to be permanently stored
This module uses 24 high precision A/D converter chip hx711. It is a specially designed for the high precision electronic scale, with two analog input channel, the internal integration of 128 times and programmable gain amplifier. The input circuit can be configured to provide a bridge type pressure (such as pressure weighing sensor mode). It is of high precision, low cost and ideal sampling front-end module. Weight:5 g Size:40mmx20mm/1.56″x0.79″(inch) (approx)
Output TTL level can be detected with the micro controller. The power supply can be 3-5V. It can also access PLC24V level. The PLC input terminal of the PLC COM power supplies 24V input termination of the board signal output OUT, optocoupler board GND power negative.
Blue 2P 5.0 terminal connected to 220V voltage. 3P terminal connected to the micro controller input.
This load sensor, sometimes called a strain gauge, is the same one found in digital bathroom scales (you know, the ones you use in January for your New Year’s resolutions, and then forget about a month later). This sensor can measure up to about 110 pounds.
This temperature sensor and module makes use of the Maxim MAX6675 K-Thermocouple to digital converter IC to provide a micro controller compatible digital serial interface (SPI compatible) to provide accurate temperature compensated measurement of the supplied K-Type thermocouple sensor. It has a 12 bit resolution providing temperature readings from 0oC to 1024oC (max temperature of supplied sensor is 450oC) with a resolution of 0.25oC.
Reviews
There are no reviews yet.