This is DC 3-5V X9C103S Digital Potentiometer Board Module. The X9C103 are digitally controlled (XDCP) potentiometers. The device consists of a resistor array, wiper switches, a control section, and non-volatile memory. The wiper position is controlled by a three-wire interface.
This is DC 3-5V X9C103S Digital Potentiometer Board Module. The X9C103 are digitally controlled (XDCP) potentiometers. The device consists of a resistor array, wiper switches, a control section, and non-volatile memory. The wiper position is controlled by a three-wire interface.
Supply voltage: 3V-5V Operating Range
10k Span Potentiometer.
Three-Wire Serial Interface
Dimensions : 28 x 14 x 4 (LxWxH) mm.
Potentiometer center tap between 0-10k slide in total 100 (potentiometer wiper typical impedance 40 ohms)
VL and VH digital potentiometer sliding rheostat port corresponding to the low-end and high-end, allowing the input voltage range -5V to + 5V.
Reviews
There are no reviews yet.
Only logged in customers who have purchased this product may leave a review.
Related Products
0 out of 5
PN532 NFC and RFID Reader & Writer Module
₦ 9,000
The PN532 is a widely used and supported NFC chip. This module will allow you to add NFC and RFID functionality to your project, allowing you to interact with phones, read and write NFC tags and RFID tags.
Features
Typical Operating Distance have been updated to 5cm~7cm reading distance
Work in NFC Mode or RFID reader/writer Mode
RFID reader/writer supports:
Mifare 1k, 4k, Ultralight, and DesFire cards
ISO/IEC 14443-4 cards such as CD97BX, CD light, Desfire, P5CN072 (SMX)
Innovision Jewel cards such as IRT5001 card
FeliCa cards such as RCS_860 and RCS_854
Plug and play, Arduino compatible
Built in PCB Antenna, with 4cm~6cm communication distance
On-board level shifter, Standard 5V TTL for I2C and UART, 3.3V TTL SPI
Work as RFID reader/writer
Work as 1443-A card or a virtual card
Exchange data with other NFC devices such as smartphone
Output TTL level can be detected with the micro controller. The power supply can be 3-5V. It can also access PLC24V level. The PLC input terminal of the PLC COM power supplies 24V input termination of the board signal output OUT, optocoupler board GND power negative.
Blue 2P 5.0 terminal connected to 220V voltage. 3P terminal connected to the micro controller input.
Single-phase AC output module equipped with ZMPT101B series of high precision voltage transformer and high precision op-amp current. Modules can be measured within 250V AC voltage, the corresponding output mode can be adjusted.
Optical fingerprint sensor with UART interface can be easily connected to micro-controller or Single board computer for authentication and security functionality. Easily Secure your project with bio-metrics – this all-in-one optical fingerprint sensor will make adding fingerprint detection and verification super simple. Up to 162 fingerprints can be stored in the on-board FLASH memory.
his thermoelectric cooling lets you heat up or cool things simply by reversing the polarity of the wires. One side heats up while the other cools. It can be used for CPU cooling, Video Card, Mini fridge and other cooling/heating applications and even for electricity generation!
Reviews
There are no reviews yet.