-
2 x 2032 Coin Cell Battery Holder – 6V Output with On & Off switch
₦ 2,000This battery holder with On/Off Switch carries two CR2032 coin cells with 30cm black and red leads! Perfect for robotic ,electronic and communication projects
- Very compact design
- Holds Two CR2032 coin batteries
- High Quality Plastic
- Perfect for soldering
- On and Off Switch
Qucik View -
A6 GSM & GPRS Module
₦ 13,000A module that supports dual-band GSM/GPRS network, available for GPRS and SMS. Comes ready to keep your project connected via phone calls, SMS, or the Internet.
- Working frequency: quad-band network, 850 / 900 / 1800 / 1900MHz
- Working voltage: 4.5~5.5V DC (On-board voltage regulator circuit supply power for A6 module)
- Working current: maximum of 2A
- Sleep current: 5mA
- Onboard Micro SIM card holder, you can install Micro SIM card
- Onboard Micro USB interface for external power supply
- Communication Interface: TTL serial port
- Baud rate: 115200bps and it can also be set by AT command.
- Interface logic voltage: 3.3V
- Make and answer phone calls using a headset and electret microphone.
- Send and receive SMS messages.
- Send and receive GPRS data (TCP/IP, HTTP, etc.)
Qucik View -
ST-Link V2 STM8/STM32 Programmer & Emulator
₦ 10,000This pocket friendly USB programmer and debugger allows STM8 and STM32 (ARM) microcontrollers to be programmed and debugged.
Product Features:
- Support for all the STM8 devices via SWIM interface
- Support for all STM32 devices with SWD interface
- Debugging : run at full-speed, single-stepped, breakpoints, viewing variables and registers, etc.
- Programming : supports FLASH ROM, EEPROM, AFR, etc.
- Onboard 500mA self-recovery fuse to avoid harming by short circuit
- Dual voltage output (3.3V/5V), easy for debugging/programming
- Standard USB interface to PC
- USB2.0 combined with SWIM/SWD interfaces : quick response for debugging & fast speed for programming
- Upgradable firmware
The board supports any of the following softwares:
- ST – LINK Utility 2.0 and above
- STVD 2 and above
- STVP 3.2.3 and above
- IAR EWARM V6.20 and above
- IAR EWSTM8 V1.30 and above
- KEIL RVMDK V4.21 and above
- ATOLLIC
- TASKING
Qucik View