• 0 out of 5

    ST-Link STM8/STM32 v2 Programmer & Emulator


    This pocket friendly USB programmer and debugger allows STM8 and STM32 (ARM) microcontrollers to be programmed and debugged.

    Product Features:


    • Support for all the STM8 devices via SWIM interface
    • Support for all STM32 devices with SWD interface
    • Debugging : run at full-speed, single-stepped, breakpoints, viewing variables and registers, etc.
    • Programming : supports FLASH ROM, EEPROM, AFR, etc.
    • Onboard 500mA self-recovery fuse to avoid harming by short circuit
    • Dual voltage output (3.3V/5V), easy for debugging/programming
    • Standard USB interface to PC
    • USB2.0 combined with SWIM/SWD interfaces : quick response for debugging & fast speed for programming
    • Upgradable firmware



    The board supports any of the following softwares:


    • ST – LINK Utility 2.0 and above
    • STVD 2 and above
    • STVP 3.2.3 and above
    • IAR EWARM V6.20 and above
    • IAR EWSTM8 V1.30 and above
    • KEIL RVMDK V4.21 and above


    Quick View
    Qucik View
  • 0 out of 5

    STM8S103F3P6 Mini Dev Board


    This STM8S103 Minimum development board is suitable for STM8 enthusiast. It packs a lot of power in a very small package.

    • 16 MHz advanced STM8 core with Harvard architecture and 3-stage pipeline
    • RAM: 1 Kbyte
    • 2.95 to 5.5 V operating voltage
    • Internal, user-trimmable 16 MHz RC
    • Internal low-power 128 kHz RC
    • On-board 5V Regulator.
    • Can be powered by 5V USB port
    • Support SWIM programming.
    • 2 Built-In LEDs Power and GPIO on pin PD3 (This should flash when you power it up)
    • On board reset button
    • 8K Flash Memory
    • 640 bytes EEPROM
    • Reflash up to 10K times
    Quick View
    Qucik View